Windshield Wipers
The windshield wiper lever is located on the right side of
the steering column.
Move the lever to the following positions:
1 (High Speed): For steady wiping at high speed.
6 (Low Speed): For steady wiping at low speed.
& (Delay): Use to set a delay between wipes.
x (Delay Adjustment): Use for a delayed wiping
cycle. Turn the intermittent adjust band down for a longer
delay or up for a shorter delay. The wiper speed can only
be manually adjusted when the lever is in this position.
9 (Off): Turns off the windshield wipers.
8 (Mist): Move all the way down to mist and release
for a single wiping cycle. The windshield wipers will
stop after one wipe. Hold the band on mist longer for
more wipes.
Heavy snow or ice can overload the wipers. If this
occurs, a circuit breaker will stop the wipers until the
motor cools. Clear all ice and snow from the windshield
wiper blades before using them. If the wiper blades
are frozen to the windshield, carefully loosen them
or warm the windshield before turning the wipers on.
If they become worn or damaged, get new blades
or blade inserts.
3-9
To Next Page
Loading...
Need help?
General
