Chevrolet Fleetmaster Series 1947 User Manual

DATA
CAR SERIAL NUMBER:
Stamped on plate attached to body right front hinge pillar
above lower hinge. .
ENGINE NUMBER:
Stamped on boss on right center side of engine block to the
rear of ignition distributor.
WHEELBASE
TIRE SIZES·
TIRE PRESSURES • .
ENGINE:
Number Cylinders
Bore·
Stroke
Horsepower (A.M.A:)
Piston Displacement
Compression Ratio· •
Engine Adjustments :
Spark Plug Gap •
Breaker Point Gap •
Initial Ignition Setting:
116"
6.00 x 16"
{
26
lbs. Front
28 lbs. Rear
- 6
. 372"
- - - 3%"
- - - - . 29.4
- - 216.5 Cu. In.
. 6.5 to 1
.040"
.018"
Distributor points should break when steel ball on fly-
wheel is opposite pointer on flywheel housing.
Octane Selector:
The octane selector should be set for the grade of fuel
being used
to produce a slight "ping" on acceleration.
Carburetor Idle Adjustment - - 1 to 2 turns open
Engine Idling<Speed - . 450 to 500 RPM
Intake Valve Clearance .006" to .008" -hot
Exhaust Valve Clearance - .013" to .015" -hot
AIR CLEANER: Remove at least once every 2,000 miles and
thoroughly wash out filter element in gasoline and dip in
fresh engine oil. This should be done more frequently when
operation is over dusty roads.
UNIT CAPACITIES:
Crankcase-Oil Capacity~Refill
Transmission-Lubricant Capacity -
Rear Axle-Hypoid Lubricant Capacity .
Cooling System-Fluid Capacity (2 drain cocks)
Gasoline
Tank Capacity
5 qts.
- - 172 pts.
. 372 pts.
- 15 qts .
. 16 gals.
.fifly-n iM

Chevrolet Fleetmaster Series 1947 Specifications

General

Brand	Chevrolet
Model	Fleetmaster Series 1947
Category	Automobile
Language	English