MANUAL TRANSMISSION
To change gears, fully depress the
clutch pedal, move the gearshift lever
into gear, and slowly release the clutch
pedal.
If the gear does not engage, set the lever
in neutral, release the clutch pedal and
depress again; then repeat gear
selection.
Do not grind the clutch unnecessarily.
When operating, depress the clutch
pedal completely. Do not use the pedal
as a footrest.
HEX0019-1
Caution
It is inadvisable to drive with hand
resting on the shift lever.
BRAKES
The braking system is designed to
brake the vehicle under any conditions.
There are disc brakes for the front
wheels and drum brakes for rear
wheels. A dual-circuit brake system is
used.
If one brake circuit is ineffective, the
other circuit can still be used to stop the
vehicle but the braking distance will
increase and depressing the brake pedal
will also require a greater force.
Caution
If one of the brake circuit fails,
depressing the brake pedal will be
difficult and the braking distance
will also increase. Contact your
CHEVROLET retailer to check and
repair the braking system.
An increase in brake pedal travel
indicates that the brakes may need
repair. Consult your CHEVROLET
retailer.
Driving and Operating 89
1
3
5
2
4
R
1
4
R
3
5
2
N shift
Caution
Shifting to R (Reverse) while the
vehicle is moving forward could
damage the transmission. The repairs
would not be covered by the vehicle
warranty. Shift to R (Reverse) only
after the vehicle is stopped.
To Next Page
Loading...
Need help?
General
