VVeehhiiccllee ccaarree 220011
2. Ensure the jack is positioned
correctly with the vehicle jacking
points.
3. Set the jack to the necessary
height. Position it directly below
the jacking point in a manner that
prevents it from slipping.
Attach the jack handle (B) to the
jack (A).
Attach the wheel wrench (C) and
with the jack handle (B) correctly
aligned, rotate wheel wrench until
tyre is clear of the ground.
4. Unscrew the wheel nuts.
5. Change the wheel.
6. Align the valve hole in the wheel
cover with the tyre valve before
installing.
7. Screw on the wheel nuts.
8. Lower vehicle.
9. Install the wheel wrench ensuring
that it locates securely and tighten
each nut in a crosswise
sequence. Tightening torque is
140 Nm.
10. Stow the replaced wheel and the
vehicle tools.
11. Check the tyre pressure of the
installed tyre and also the wheel
nut torque as soon as possible.
Have the defective tyre renewed
or repaired.
To Next Page