How to Add Automatic Transmission
Fluid
Refer to the Maintenance Schedule to determine what
kind of transmission fluid to use. See Part D:
Recommended Fluids and Lubricants on page 6-14.
Add fluid only after checking the transmission fluid while
it is hot. (A cold check is used only as a reference.)
If the fluid level is low, add only enough of the proper
fluid to bring the level up to the HOT area for a hot
check. It doesn’t take much fluid, generally less
than one pint (0.5 L). Don’t overfill.
Notice: We recommend you use only fluid labeled
DEXRON
®
-III, because fluid with that label is
made especially for your automatic transmission.
Damage caused by fluid other than DEXRON
®
-III
is not covered by your new vehicle warranty.
• After adding fluid, recheck the fluid level as
described under “How to Check” earlier.
• When the correct fluid level is obtained, push the
dipstick back in all the way; then flip the handle
down to lock the dipstick in place.
Engine Coolant
The cooling system in your vehicle is filled with
DEX-COOL
®
engine coolant. This coolant is designed
to remain in your vehicle for 5 years or 150,000 miles
(240 000 km), whichever occurs first, if you add
only DEX-COOL
®
extended life coolant.
The following explains your cooling system and how
to add coolant when it is low. If you have a problem with
engine overheating or if you need to add coolant to
your radiator, see Engine Overheating on page 5-27.
A 50/50 mixture of clean, drinkable water and
DEX-COOL
®
coolant will:
• Give freezing protection down to −34°F (−37°C).
• Give boiling protection up to 265°F (129°C).
• Protect against rust and corrosion.
• Help keep the proper engine temperature.
• Let the warning lights and gages work as
they should.
5-24
To Next Page
Loading...
