Page 8
SKU 40039
1. Before each use visually inspect the Jig Saw for cracks or loose nuts or screws. Tighten if
necessary. If the unit is cracked, do not use it. Take it to an authorized service technician.
2. Keep the Rod Slot (#12a) and the Rod (#11a) clean and clear of any dirt or debris.
3. If the Jig Saw is used regularly, have an authorized service technician check the brushes
and change them every six months if they are too short. Also, have an authorized service
technician grease the internal parts when needed. Do not attempt to change brushes or
grease the internal parts yourself.
Maintenance
Rev 01/03
To Next Page
Loading...
