Why is my Chicago Electric Saw running hot and smoking?
If your Chicago Electric Saw is running hot and producing excessive smoke, there are several possible causes. First, check the water flow connection. Second, ensure that you are using an adequate amount of water and clean the pump filter. Finally, always use cold water when operating the saw; using hot or warm water can cause it to overheat.
What to do if my Chicago Electric 97360 Saw will not start?
If your Chicago Electric Saw isn't starting, there are a couple of things to check. First, make sure the outlet has power. If the outlet is functional, verify that the saw's cord is securely plugged in.
Why does my Chicago Electric Saw have excessive vibration?
Excessive vibration in your Chicago Electric Saw can stem from a couple of issues. It might be due to a bent or off-balance blade, in which case you should replace the blade with a new one. Another potential cause is a bent arbor shaft; check the shaft for run-out.
How to fix a Chicago Electric Saw when the blade spins slowly?
If the blade on your Chicago Electric Saw is spinning slowly, there are a couple of potential reasons. One possibility is that the arbor shaft is binding; check the shaft to ensure it spins freely. Another reason could be that the motor brushes are worn, and you may need to replace them.
Read before use; failure can cause serious injury.
Read all warnings and instructions to avoid injury.
Tools with three prong plugs.
Set guides, position tile, ensure water level.
Remove guard, unscrew nut, replace blade.
Ensure arrow direction, attach flanges, tighten nut.
Lists tool not starting, blade slow, vibration, running hot.
General| Brand | Chicago Electric |
|---|---|
| Model | 97360 |
| Category | Saw |
| Language | English |
To Next Page
