To Next PageTo Next Page
Need help?Do you have a question about the Chicco Activ3 and is the answer not in the manual?
General| Type | Jogging Stroller |
|---|---|
| Weight Capacity | 50 lbs |
| Stroller Weight | 27.5 lbs |
| Fold | One-hand fold |
| Wheel Type | Air-filled tires |
| Number of Wheels | 3 |
| Seat Recline | Multi-position |
| Harness | 5-point harness |
| Front Wheel | Swivel |
| Brakes | Foot-activated |
| Canopy | Adjustable |
| Storage | Large storage basket |
Remove the metal ring and pin from the front swivel mount, which is attached to the stroller frame with a cable.
Rotate the push handle upwards until it clicks into the first of its four available positions.
Secure the parent tray by wrapping its underside hook and loop tabs around the cross bar.
Clip the canopy to the stroller frame, ensuring the button correctly nests into the designated hole.
Pull the front edge of the canopy forward to open it. Reverse this action to close the canopy.
Wrap the wrist strap around the handle, secure the parent loop, and store it by wrapping the loop around the handle.
Use the lever on the left handle to lock the front wheel; press the center button to release the swivel lock.
Use the lever on the right handle to lock the brakes; press the center button to release them.
Squeeze the backrest levers and lower the backrest to the desired position.
Adjust shoulder strap height by pulling the strap through the appropriate buttonhole for a secure fit.
Flip the lever up for smooth surfaces and down for rough surfaces, ensuring both levers match.
Attach the bumper bar to the stroller's arm rest, tilting it as illustrated.
Press buttons under the bumper bar, tilt its front edge up, and lift to remove.
Use only Chicco infant car seats, ensuring proper harnessing and adherence to size/weight limits.
Move canopy back, ensure car seat is detached, grasp handle, push button, and twist handle forward.
Pull the red metal release handle to detach the front swivel wheel from the stroller.
Lay the stroller down and pull the spring release button on the wheel mount hub to remove rear wheels.
Remove bumper bar and canopy, then unzip the seat back fabric at the top of the stroller.
Wipe plastic parts with a damp cloth, dry metal parts, and consult care label for fabric cleaning.
