28 29
20A. With the Child's Tray attached
and the Stroller Backrest FULLY
RECLINED, place the Chicco infant
car seat into the Stroller Frame. The
car seat will only fit into the frame
"REAR FACING ONLY". The baby
will be facing you when pushing the
stroller. Make sure infant car seat
clicks into the stroller frame on both
sides.
Note: Pull up on the infant car seat;
make sure it is secured to stroller
frame (20B). If using the Canopy
with the infant car seat rotate the
handle down to allow the Canopy to
fully extend open.
20B
20A
1
CLICK!
CHECK!
2
“CLICK!”
WARNING
ONLY USE a Chicco infant car seat with this product. Make sure to properly
install the Child's Tray prior to using the Chicco infant car seat. Always make
sure child is properly harnessed in the car seat. Only use this product to
transport infants that are within the size and weight limitations of the infant
car seat. Refer to your Chicco infant car seat Owner's Manual for additional
warnings and use instructions before using this product.
Using the Chicco Infant Car Seat
How to Remove the Accessory Pocket
19A. Pull the Accessory Pocket out of
the opening on the Parent Tray.
19B. Locate 3 fabric tabs on the
bottom of the Parent Tray. Thread
the fabric tabs up through the
opening that they are threaded
through.
19C. Pull up on the Accessory Pocket
to remove it from the Parent Tray.
19A
19B
19C
To Next Page
Loading...
