8 9
How to use Glider
5B. The safety harness can be released
by pressing the button on the center
of the Crotch Strap Buckle and pulling
both Waist Clips out.
5A. Slide both Waist Clips into the
Crotch Strap Buckle as shown. Pull on
both sides to make sure the Clips are
secured to the Buckle.
WARNING
Avoid serious injury from falls or sliding out. Always secure child in the restraint.
Never leave child unattended in Glider. Always keep child in view.
“CLICK!”
6. The length of the Waist Straps can
be adjusted by pressing the tab at the
end of the Waist Strap Clip and pulling
on the strap to tighten or loosen to
better fit your child.
6
5A
5B
4A. Slide the Seat Fabric (A) onto the
Top Support Frame. Pull the bottom
edge of the Seat Fabric down over the
lower section of the Support Frame.
4B. To secure the Seat Fabric to the
Support Frame, wrap the corners of
the fabric under the bottom of the
Support Frame and attach both snap
buttons.
4C. Locate the center fabric loop on
the back of the Seat Frame, as shown.
Secure the loop over the tab.
How to Assemble Glider
4A
4B 4C
To Next Page
Loading...
Need help?
General
