that the product and all its compo-
nents don’t show signs of damage
caused by transportation.
• WARNING: Do not use the seat if it
has any broken or damaged parts.
• WARNING: When not in use, the
seat must be kept out of the reach
of children.
• WARNING: Do not use the seat with
more than one child at time.
• WARNING: Before mounting the
seat on the stool structure, make
sure that the structure is properly
fastened and all its components are
assembled correctly.
• WARNING: Do not step up on the
stool.
COMPONENTS
A – Seat
B - Stool structure
C - Seat rear fastener
D - Seat front pins
E - Seat release sliding buttons
F - Leg rest
G - Leg rest adjustment buttons
H - Rear fastener slot
I - Front pin fastening holes
CLEANING & MAINTENANCE
Clean with a soft cloth soaked in water. Never use abrasive
detergents or solvents.
USE
The highchair can be used in stool mode for children aged
36 months and older and weighing up to 30 kg.
INSTALLATION
To install the seat “A” correctly on the stool structure “B”:
1) Fold the leg rest “F” using the side adjustment buttons “G”
and making it turn completely to the back of the struc-
ture until it reaches closed position (Fig. 1-2).
WARNING: When using the seat, the leg rest must be kept
in closed position.
2) Take the seat “A” from the sides and insert the rear fasten-
er “C” in the slot “H” on the stool “B” (Fig. 3-4).
3) Then turn the front part of the seat “A” down and push on
the front part until you hear the engagement click of the
front pins “D” in the holes “I” in the stool structure (Fig. 5).
REMOVAL
To remove the seat “A” correctly from the stool structure “B”:
1) Lower the stool structure surface following the instruc-
for use. The warranty shall not therefore apply in the case
events. For the duration of warranty on conformity defects
cable in the country of purchase, where provided.