When not in use, your ChickenGuard will
go on Energy saving mode.
Press the Power/Menu button. If the display is still off, check that all 4 batteries
have been installed in the correct orientation and fully charged. Try a new set if
possible or use external power to see if that solves the issue.
If you require further assistance, visit www.chickenguard.com
Error message “Motor missing”
The motor is not connected to the front
panel
Remove the 4 screws and the front panel. Connect the white plug attached to
the motor wires to the plug in the front panel.
Error message “Front cover missing”
The sensor in the front panel cannot read
the magnets in the spindle. The sensor
counts the rotations of the spindle using
these magnets to count the number of
rotations needed when the door is
closing.
Attach the front panel to the unit using the screws.
Nothing happens or little movement
detected after pressing the Menu
button to start the calibration
This could be due to the lack of weight
detected during the calibration.
Ensure the string is attached to the door before setting up your ChickenGuard.
3/5
Instructions
STANDARD/PRO
To Next Page
Loading...