Mounting Bracket
x 2
STEP 1: DETERMINE INSIDE
OR OUTSIDE MOUNT
a. Inside/Ceiling or Inside/Wall Mount
(A minimum 1 3/4 in. depth is required or 3 3/4 in. depth
for flush mounts.)
Place the mounting brackets on each end of the blind’s
headrail.
Mark the position of the mounting brackets with a pencil
Align with pencil marks with the brackets then drill into
the window frame using the screws provided. Use a 1/8
inch drill bit to make a hole.
Check Components
Prepare necessary tools
CORDLESS 2 INCH
FAUX WOOD BLINDS
b. Wall or Outside Mount
(A minimum 1 3/4 in. flat wall space is necessary)
Place the mounting brackets on each end of the blind’s
headrail against the wall(on the window frame or above
the window frame).
Mark the position of the mounting brackets with a pencil.
Align with pencil marks with the brackets then drill into
the window frame using the screws provided. Use a 1/8
inch drill bit to make a hole.
1)
2)
3)
1)
2)
3)
Note:
If your product includes a center bracket: Installing at the
center of the blinds will provide additional support to
blinds. Center support bracket are included for blinds
ranging from 37” - 84”
STEP 2: ATTACH VALANCE CLIPS
STEP 3: ATTACH WAND
Insert the wand hook gently into the tilter as shown below.
or
STEP 4: MOUNT THE HEADRAIL
Mount your blind by inserting the headrail into the open
mounting brackets. Snap the bracket until you hear a “click”
Components
Faux Wood Blinds
Valance
x 2 x 3 x 4 x 5Valance Clips
Wand
Hold Down Bracket
x 4 x 6 x 8 x 10Screws
12-36 37-48 49-72 73-84
Blinds Width ( inches )
x 0 x 1 x 2 x 3
Center Support Bracket
Inside/Ceiling
Outside/ Wall
Insert the valance
clips.
Side Returns (2 choices)
Side Returns Clip
1/8” drill bit
x 2
x 2
x 2
x 2
x 1
To Next Page
Need help?
General
