4 Operating Instructions
The chiller may only be transported in original packaging to the site of initial operation. In case of damage the ma-
nufacturer must be informed immediately. If the unit is moved to another location in a factory, all connections must
be disconnected from the unit. Moving the unit to another location must be carried out without causing damages.
If damage occurs despite these instructions, the unit must be checked by an expert and repaired as required before
it is put into operation again.
Note:
The Manufacturers Liability excludes any Damage to the Chiller
subsequent to Transportation.
When transporting the unit, consider the weight limits indicated in the technical data.
Use a fork-lift, truck or a crane with the corresponding load-capacity.
The fully-hermetic compressor is mounted on rubber. Avoid vibrations during transport.
Failure to observe can result in compressor damage.
2 TRANSPORT
To Next Page
Loading...