EN
Prepare with requirements
Installation Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your Fridge/Freezer near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an out-building such as a garage or annex
ensure that the Fridge/Freezer is placed above the damp course, otherwise condensation will occur on the Fridge/Freezer
cabinet. Never place the Fridge/Freezer in a wall recess or into fitted cabinets or furniture. When your Fridge/Freezer is
working, the grille at the back may become hot and the sides warm. Therefore, the back part of the refrigerator / freezer
must be installed at least 50mm of free space, both sides should be left more than 100mm. Do not drape the
Fridge/Freezer with any covering.
Dimensions in mm
W D H A B C(°) E F
545 590
1700
845 1095 125 50 100
Note：Figure 1, Figure 2 only as a product space demand size schematic diagram.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may cause
you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final location, adjust the
leveling feet at the front by turning them.
Cleaning before use
To Next Page
