Installation
7
Procedure for adjusting the washer feet:
1. After determining which washer feet need to be
extended, have someone lift up on the washer
slightly to take pressure off the foot to be
adjusted.
2. Turn the grey plastic foot to extend it downward
as far as necessary to raise the corner of the
washer the correct amount to level the washer.
3. When the height of the foot is correct, use a 17
mm open end wrench to tighten the locknut
against the washer bottom. The locknut should
be tighten against the bottom of the washer to
lock the foot in place.
Choosing the Right Location
● Locations the appliance is not to be
installed
In a damp place or where the appliance may be
exposed to rain, etc.(As this could cause electric
shock or fire)
Locations that are uneven, or unstable (As this
could cause vibration and noise).
In direct sunlight (As this could cause malfunction
or deformation)
Within, or on top of, unstable surfaces, including
but not limited to benchtops, timber shelving, or
-
-
-
-
cabinets
！
CANTION: Do NOT install where temperatures
may reach freezing
● Set-in Installation
Install the appliance with easy access to the
power plug and socket.
Install the appliance where there is enough space
around it.
-
-
(a) 3cm or more
above
5cm or more
behind
2cm or more on
the left side
2cm or more on
the right side
64cm or more
(b)
(c)
(d)
(e)
！
CAUTION: Do NOT let metallic portions of the
appliance come into contact with metal sinks or
other appliances.
To Next Page
