Need help?Do you have a question about the ChlorKing SAG Series and is the answer not in the manual?
General| Category | Plumbing Product |
|---|---|
| Brand | ChlorKing |
| Series | SAG |
| Chlorine Capacity | Varies by model |
| Operating Pressure | 20-80 PSI |
| Material | PVC |
| Control System | Automatic |
Overview of the Sentry Aqua Guard UV system for commercial pools, its capabilities and operation.
Explains how the UV Light Chamber and Power Supply function to sterilize water.
Details the unit's effectiveness, design for supplementary disinfection, and lists model numbers.
Provides guidance on sizing UV sterilizers based on flow rate and local codes.
Details installation dimensions for 120 Watt chambers with 2" flanges.
Details installation dimensions for the 120 Watt PVC chamber.
Details installation dimensions for 240 Watt chambers with 3" flanges.
Details installation dimensions for the 240 Watt PVC chamber.
Details installation dimensions for 480 Watt chambers with 4" flanges.
Details installation dimensions for the 480 Watt PVC chamber.
Details installation dimensions for 720W and 960W chambers with 6" flanges.
Details installation dimensions for 1200 Watt chambers with 8" flanges.
Provides dimensions for flanged strainer spools based on pipe size.
Provides dimensions for union strainer spools based on pipe size.
Instructions for receiving and inspecting the unit for shipping damage.
Guidelines for storing the unit before installation.
Important safety instructions and precautions for installation and operation.
Critical warnings regarding electrical safety, modifications, children, component replacement, and UV exposure.
Emphasizes personnel familiarity, safe operation, and proper maintenance procedures.
Advises on evaluating facility needs and tools for a smooth installation.
Instructions for mounting the power supply near the UV chamber and outlet.
Guidance on positioning and securing the UV chamber, including vertical and horizontal orientations.
Detailed steps for carefully installing the quartz sleeve assembly into the chamber.
Instructions for connecting the lamp connector and lowering the lamp into the quartz sleeve.
Emphasizes that the entire water volume must pass through the chamber, no bypass.
Instructions for installing the strainer on the outlet side of the UV chamber.
Details on how to plumb the pressure switch to the pump discharge.
Steps for installing the air bleed on vertical mount chambers using fittings and tubing.
Instructions for wiring 120V and 230V systems, including bonding and GFCI protection.
Details on connecting the safety cover micro-switch to the power supply.
Steps for installing the UV sensor, o-ring, and quartz window.
Requirements and methods for bonding the UV system power supply and chamber.
Steps to follow for initial system startup, including filling and warming up lamps.
Explains how to read the UV meter and interpret the LED indicators for dose levels.
Outlines daily checks of the UV meter and LEDs, and cleaning procedures.
Cautions on handling delicate glass components like lamps and quartz sleeves.
Instructions for chemically cleaning NSF models using a cleaning solution.
Information regarding lamp service life and the need for replacement after 13,000 hours.
Steps to take for technical assistance or warranty support.
Procedure for returning a product for warranty evaluation, including RA numbers.
Requirements for validating warranty and submitting a claim.
Details the warranty periods for different components of the UV system.
Explains the warranty limitations for quartz sleeves due to their fragile nature.
Covers general warranty exclusions, voiding conditions, and liability limitations.
To Next Page