Extension Hopper
5
MA773H
Safety Information
Caution, Warning and Danger Decals have been placed on the equipment to warn of potentially
dangerous situations. Care should be taken to keep this information intact and easy to read at all times.
Replace missing or damaged safety signs.
Using the equipment for purposes other than specified in this manual may cause personal injury and or
damage to the equipment.
Safety–Alert Symbol
This is a safety–alert symbol. When you see this symbol on your
equipment, be alert to the potential for personal injury. This equipment is
designed to be installed and operated as safely as possible...however,
hazards do exist.
Signal Words
Signal words are used in conjunction with the safety–alert symbol
to identify the severity of the warning.
DANGERindicates an imminently hazardous situation
which, if not avoided, WILL result in death or serious
injury.
WARNINGindicates a potentially hazardous situation
which, if not avoided, COULD result in death or serious
injury.
CAUTIONindicates a hazardous situation which, if not
avoided, MAY result in minor or moderate injury.
DANGER: Moving Auger
This decal is placed on the Panel Weldment.
Severe personal injury will result, if the electrical power is not
disconnected, prior to servicing the equipment.
DANGER: Electrical Hazard
Disconnect electrical power before inspecting or servicing equipment
unless maintenance instructions specifically state otherwise.
Ground all electrical equipment for safety.
All electrical wiring must be done by a qualified electrician in
accordance with local and national electric codes.
Ground all non-current carrying metal parts to guard against electrical
shock.
With the exception of motor overload protection, electrical disconnects
and over current protection are not supplied with the equipment.
To Next Page
Loading...
Need help?
General
