Model 108 Two Motor Tandem Installation Instruction
3
SAFETY INFORMATION
Caution, Warning and Danger Decals have been placed on the equipment to warn of potentially dangerous
situations. Care should be taken to keep this information intact and easy to read at all times. Replace missing or
damaged safety signs.
Using the equipment for purposes other than specified in this manual may cause personal injury or damage to the
equipment.
Safety–Alert Symbol
This is a safety–alert symbol. When you see this symbol on your equipment,
be alert to the potential for personal injury. Chore-Time equipment is
designed to be installed and operated as safely as possible...however,
hazards do exist.
DANGER
WARNING
CAUTION
Signal Words
Signal words are used in conjunction with the safety–alert symbol to
identify the severity of the warning.
DANGER ........... indicates an imminently hazardous situation
which, if not avoided, WILL result in death or
serious injury.
WARNING .........indicates a potentially hazardous situation
which, if not avoided, COULD result in death
or serious injury.
CAUTION .......... indicates a hazardous situation which, if not
avoided, MAY result in minor or moderate
injury.
DANGER—MOVING AUGER
This decal is placed on the Clean-Out Cover of the
FLEX-AUGER Control Unit.
Severe personal injury will result, if the electrical
power is not disconnected, prior to servicing the
equipment.
DANGER—ELECTRICAL HAZARD
Disconnect electrical power before inspecting or servicing equipment
unless maintenance instructions specifically state otherwise.
Ground all electrical equipment for safety.
All electrical wiring must be done by a qualified electrician in
accordance with local and national electric codes.
Ground all non-current carrying metal parts to guard against electrical
shock.
With the exception of motor overload protection, electrical disconnects
and over current protection are not supplied with the equipment.
To Next Page
Loading...
Need help?
General