7. Install the backup lamp socket into the trunk lid lamp
housing.
8. Rotate backup lamp socket clockwise 1/4 turn to lock
it into place.
9. Reposition the inner deck panel and secure with a
push pin if removed.
10. Install the access cover.
Stop/Rear Turn Signal Lamp
1. Open the trunk lid.
2. Remove the tail lamp housing beauty cover by grasp-
ing the top edge and pulling rearward to expose the
tail lamp housing bolts.
3. Remove the tail lamp housing bolts
Tail Lamp Beauty Cover
7
MAINTAINING YOUR VEHICLE 649
To Next Page
Loading...
