Complete The Android Pairing Procedure:
1. Confirm the passkey shown on the mobile phone
matches the passkey shown on the Uconnect sys-
tem then accept the Bluetooth pairing request.
NOTE:
Some mobile phones require the PIN to be entered
manually, enter the PIN number shown on the
Uconnect screen.
For further information on Uconnect Phone, please
refer to “Uconnect Phone” in your Uconnect Owner’s
Manual Supplement.
Automatic High Beam —
If Equipped
This system automatically controls the operation of
the headlamp high beams as oncoming vehicles ap-
proach.
• The Automatic High Beam Headlamp Control can
be turned on or off using the Uconnect System.
• Push the turn signal lever away from you.
• With the headlight switch in the “AUTO” position,
the high beams are controlled automatically.
• Pull the turn signal lever toward you to manually
deactivate the system.
• To improve system recognition of crossing traffic,
and to limit use in a residential area, the vehicle
must be moving at a speed greater than 20 mph
(32 km/h) before the Automatic High Beam Mod-
ule (AHBM) begins requesting high beam
activation.
Pairing Request
LIGHTS
To Next Page
Loading...
