NOTE:
If the windshield or Automatic High Beam Headlamp
Control mirror is replaced, the mirror must be re-
aimed to ensure proper performance. See a local au-
thorized dealer.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S.
Residents) or www.owners.mopar.ca (Canadian Resi-
dents).
Speed Control
When engaged, the Speed Control takes over accel-
erator operations at speeds greater than 25 mph
(40 km/h).
To Activate
Push the on/off button. To turn the system off, push
the on/off button a second time. The system should
be turned off when not in use.
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has
reached the desired speed, push the SET (+) or the
SET (-) button and release. Release the accelerator
and the vehicle will operate at the selected speed.
To Deactivate
A soft tap on the brake pedal, pushing the CANC
button, or normal brake pressure while slowing the
vehicle will deactivate Speed Control without erasing
the set speed memory. Pushing the on/off button or
turning the ignition switch OFF erases the set speed in
memory.
To Resume Speed
To resume a previously set speed, push the RES but-
ton and release.
Speed Control Switches
1 — Push Cancel
2 — Push Set (+)/Accel
3 — Push Resume
4 — Push On/Off
5 — Push Set (-)/Decel
SPEED CONTROL
To Next Page
Loading...
