Chrysler JOURNEY - Understanding the Features of Your Vehicle

uconnect™ phone Features
Language Selection
To change the language that the uconnect™
phone is using:
• Press the
button to begin.
• After the ⬙Ready⬙ prompt and the following
beep, say the name of the language you
wish to switch to (English, Dutch, French,
German, Italian, or Spanish, if so equipped).
• Continue to follow the system prompts to
complete language selection.
After selecting one of the languages, all
prompts and voice commands will be in that
language.
NOTE:
After every uconnect™ phone language
change operation, only the language-specific
32-name phonebook is usable. The paired
phone name is not language-specific and
usable across all languages.
For command translations and alternate com-
mands in supported languages, refer to “Com-
mand Translations.”
Emergency Assistance — If Equipped
If you are in an emergency and the cellular
phone is reachable:
• Pick up the phone and manually dial the
emergency number for your area.
If the phone is not reachable and the
uconnect™ phone is operational, you may
reach the emergency number as follows:
• Press the
button to begin.
• After the ⬙Ready⬙ prompt and the following
beep, say ⬙Emergency⬙ and the uconnect™
phone will instruct the paired cellular phone
to call the emergency number.
NOTE:
• The default number is 112. The number
dialed may not be applicable with the
available cellular service and area.
• If supported, this number may be pro-
grammable on some systems. To do this,
press the
button and say ‘Setup’,
followed by ‘Emergency’.
• The uconnect™ phone does slightly
lower your chances of successfully mak-
ing a phone call as to that for the cellular
phone directly.
WARNING!
Your phone must be turned on and paired to
the uconnect™ phone to allow use of this
vehicle feature in emergency situations when
the cellular phone has network coverage and
stays paired to the uconnect™ phone.
Breakdown Service — If Equipped
If you need Breakdown service:
• Press the
button to begin.
• After the ⬙Ready⬙ prompt and the following
beep, say ⬙Breakdown service.⬙
NOTE:
The Breakdown service number has to be setup
before using. To setup, press the button
and say ⴖSetup, Breakdown Serviceⴖ and follow
prompts.
69