When a valid kicking motion is completed, the sliding
door will chime, the hazard lights will flash and the
sliding door will open almost instantaneously. This
assumes all options are enabled in the radio.
NOTE:
• To open the Hands-Free Sliding Doors requires a
valid Passive Entry key fob within 5 ft (1.5 m) of the
door handle. If a valid Passive Entry key fob is not
within 5 ft (1.5 m), the door will not respond to any
kicks.
• The Hands-Free Sliding Door will only operate
when the transmission is in Park.
• If anything obstructs the Hands-Free Sliding Doors
while opening, the sliding doors will automatically
reverse to the closed position, provided it meets
sufficient resistance.
• If a power sliding door encounters multiple ob-
structions within the same cycle, the system will
automatically stop.
• The Hands-Free Sliding Doors feature may be
turned on or off in Uconnect Settings. The Hands-
Free Sliding Doors feature should be turned off
during Jacking, Tire Changing, and Vehicle Ser-
vice.
For further information and applicable warnings and
cautions, please refer to your Owner’s Manual at
www.chrysler.com/en/owners/manuals.
Hands-Free Liftgate — If
Equipped
To open the Hands-Free Liftgate, use a straight in and
out kicking motion under the vehicle activation zone in
the general location below the liftgate door handle.
Do not move your foot sideways or in a sweeping
motion or the sensors may not detect the motion.
Vehicles Equipped With A Trailer Tow Package
If your vehicle is equipped with the Trailer Tow
Package, the hands-free activation zone(s) for the
Power Liftgate will be located on the left and right
side of the receiver. Use a straight kicking motion
under either activation zone to open the Hands-
Free Liftgate.
Hands-Free Liftgate Activation Zone
Hands-Free Liftgate Trailer Tow Activation
Zones
To Next Page
Loading...
