EN EN
Introduction
This is a contact wireless water detector, which works based on the
theory of liquid conductivity. The performance is reliable and the
installation is easy. When the liquid reaches to the two probes of the
detector, it will send wireless signal to the control panel. It can be
widely used in computer rooms, warehouses and any places need
to be protected from water. Two pieces of AAA 1.5V LR03 batteries
are included in the detector, which enables 12 months standby.
Product Overview
LED Indicator
Transmitter
Probe
LED Indication
Flash once: Liquid is detected, sending wireless signal to the control
panel.
Flash once every two seconds: Low battery. Please replace the
battery immediately.
PCB Layout
AAA 1.5V LR03
AAA 1.5V LR03
Tamper Switch
Connect to the Control Panel
Make sure the control panel is under learning status, then simulate
an alarm case by touching the probe of detector with the water.
When an alarm signal is received by panel, one beep is heard,
indicating a successful connection.
To Next Page
Loading...
