2
General Description
The lock is operated by a 6 digit PIN number;
the lock can accept two individual user codes
which are programmed separately – the
PRIMARY and the USER codes.
It is possible to set a time-delay feature
whereby a set period of time (0 to 99 minutes)
has to elapse between entering a valid opening
code and it being possible to open the safe.
A short buzzer note and green LED light
validate every keypad entry (except the “ENTER” key). If more than 10 seconds
elapses between button entries or if the complete code entry exceeds 30 seconds
in length the lock will automatically go back into “sleep mode” and the code entry
process needs to begin again.
Entering the correct PIN code followed by pressing “ENTER” will cause both the
buzzer to sound and green LED to flash, twice. The green LED will then flash for a
further 7 seconds. THE HANDLE MUST BE TURNED WITHIN THIS 7 SECONDS PERIOD
otherwise the safe will return to the locked state.
Entering an incorrect code causes the buzzer to sound and the red LED to light.
Entering three successive incorrect codes causes the lock to close down for 5
minutes. During this time the red LED will flash every five seconds and the lock will
not operate even if the correct code is used. The 5 minutes countdown will
continue even if power is cut to the lock. Attempting to enter a code of more than
8 digits is also considered an incorrect code.
Entering in fewer than 6 digits before pressing the “ENTER” key is not considered
an incorrect code but will produce a long buzzer note and the red LED will light.
Entering the correct code will open the safe without further delay.
UPON LEAVING THE FACTORY THE LOCK IS SET ON THE PRIMARY
CODE:
To Next Page
Loading...
