Need help?Do you have a question about the CIAT AQUACIAT 2 ILDC Series and is the answer not in the manual?
Essential to follow manual for installation, startup, and adjustment to avoid accidents.
Use designated handling holes, textile slings, and ensure proper balance.
Shows operating limits for cooling mode based on outside and evaporator temperatures.
Details operating limits for cooling mode for specific unit types.
Illustrates operating conditions for heating mode based on temperatures.
Outlines compliance with standards and the importance of wiring diagrams.
Details voltage, phase, and frequency requirements for power supply.
Emphasizes the need for protection against power surges and atmospheric causes.
Introduces the microprocessor-based CONNECT regulation module.
Lists key functions like regulation, diagnosis, and remote control.
Procedure for acknowledging faults triggered by safety devices.
Explains the function of the LP sensor for safety.
Details HP pressostat and sensor functions for safety and regulation.
Describes sensors that protect the evaporator from freezing.
Lists regulating and safety devices with their electrical symbols.
Describes the function of each regulating and safety device.
Essential checks to perform before starting the unit for the first time.
Emphasizes that only qualified engineers should start up the unit.
Step-by-step guide for starting the unit, including checks and setpoints.
Correct methods for shutting down the unit, excluding the master switch.
Procedures to ensure the correct refrigerant fluid load for optimal operation.
Key checks during startup, such as compressor rotation and current.
How to adjust water flow using the adjusting valve for desired nominal flow.
Procedures for cleaning, coil checks, and regular inspections.
Critical safety precautions for personnel performing maintenance.
General advice and common causes for unit anomalies.
Detailed table of anomalies, their likely causes, and corrective instructions.
To Next Page
General