CIC Frilled Lizard - Product Overview and Preparation; Frilled Lizard Robot Introduction; Tools Required for Assembly; Mechanical Parts Catalog

(1:1)(1:1) (1:1)
Product Introduction
Mechanical Parts List
Gear With Shaft
Pinion Gear(White)
Tapping Screw
Gear(Red)
Gear(Purple)
Hex Shaft(Middle) Hex Shaft(Long)Hex Shaft(Short)
Gear(White)Gear(Yellow)
QTY
1
511
111
QTY
1
QTY
1
QTY
QTY QTY QTY
QTY QTY QTY
2
P4P3P2P1
P5 P6 P7
P8 P9
P10
Frilled Lizard Robot has an infrared sensor that is programmed to “escape” or “follow-me”.
If the infrared sensor is activated in the “escape” mode the robot will automatically act
“shocked!”, spreading its frill, dropping its jaw, illuminates its bicolor LED eyes and will
scurry away from you until it escapes to a safe distance. If the infrared sensor is switched
to the “follow-me” mode using the 2 way function switch, then the robot will assess danger
by bluffing the attacker (unfurling and shaking its frill). When the robot does not sense
danger it will proceed to follow you like a pet lizard.
Thank goodness, that unlike the wacky frilled lizard that roams in Australia’s tropical
woodland, this Frilled Lizard Robot is whimsically kooky and fun to build.
Product contains functional edges and sharp points.
Frilled Lizard Robot KIT
1
Alkaline batteries are
recommended
Tools You May Need
Diagonal Cutter
Knife
Battery(AAA) x 4 Screwdriver
Hammer