Need help?Do you have a question about the CIE-Group AVID2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal-to-Noise Ratio | >85dB |
| Total Harmonic Distortion | <0.1% |
| Input Impedance | 47k Ohms |
| Inputs | RCA |
| Outputs | Binding Posts |
| Frequency Response | 20Hz - 20kHz |
Instructions for locating and referencing the Bluetooth pairing code for the AVID2 amplifier.
Details the AVID2's Bluetooth receiver module, pairing process, and LED indicators for wireless audio playback.
Explains the available audio input types: 2x Stereo Phono and 1x 3.5mm Jack, noting input priority.
Details the rear 'hard-wired' audio input, its parallel connection to the 3.5mm jack, and potential mixed output effects.
Explains the switch for adjusting input sensitivity between Hi and Lo levels based on signal source.
Describes Bass and Treble controls available via the IR remote for sound adjustment.
Details the Left & Right loudspeaker balance feature controlled via the IR remote.
Notes that the 'Bass Boost' Loudness function is not enabled on this AVID2 model.
To Next Page