10
Setting the Year:
Initial year is 2018, when the year display is flashing, press the memory button, the year w ill
increase by I year e ach, hold the memory button and it will increase continuously 1 by 1 , until
2049, and then rollover to 2018, once the year Setting is OK, press SET button to confirm.
Setting Month/Date:
Initial Month/Date is 1/01, when the Month display is flashing, press the memory button, the
month will increase by 1, press SET button to confirm, and do in the same way to set the date.
Press SET button to confirm.
Setting Time :
When the hour display is flashing, press the memory button, the hour will increase by 1, press
SET button to confirm, a nd do in the same way to set the minute. Press SET button to confirm.
Setting Volume:
When display with SP is flashing, press memory button to switch volume 1, volume 2, volume
3 or OFF. Press SET button to confirm.
C. Record Delete
When yo u checking the memory data, long press m emory to delete existing user
measurement data.
Note: You can’t delete all measurement record from the monitor storage at one time, if you
decide to delete the all record, please keep the record in another way, in case you need it
some days later. Take the battery out won’t lead to a record missing.
4.2. Cuff tube connection
Insert the cuff tube into the opening on the left side of the monitor indicated by the drawing of a
cuff.
5. Measurement Procedure
Note: You should always be seated and calm before an d during mea surement.
5.1. Before measurement:
• Avoid eating and s moking as well as all forms of exertion directly before measurement. These
factors influence the measurement result. Find time to relax by sitting in an armchair in a quiet
atmosphere for about ten minutes before taking a measurement.
• Remove any garment that fits closely to your upper arm.
• Always measure on the same arm (normally left).
• Always compare measurements take n at the same time of day, since blood pressure
changes during the course of the day, as much as 20-40mmHg.
5.2. Common sources of error:
Note: Comparable blood pressure measurements always require the same co nditions!
•Conditions should always be quiet.
•All efforts by the user to suppo rt the arm can increase bloo d pressure. Make sure you are in a
To Next Page
Loading...