12
Picture-06
Change the cuff may result in unacceptable risks,the operator should pay attention to the
following:
• Only use Jamr au thorized cuffs, as those not approved for u s e with the device may provide
inaccurate measurements, injury, and/or damage the device.
• Do not force c uff connection into the opening.
• Do not forcefully bend the arm cuff or air tube. Do not fold tightly.
5.4. Measure Procedure
Refer to picture 07
The monitor is designed to take measurements and store the measurement values in
memory for two people using User ID A and User ID B.
1. Sit comfortably in a chair with your feet flat on the floor.
2. Select your User ID (A or B).
Stretch your arm forward on the desk and keep relaxing, make sure the palm of hand is
upturned. Make sure a rm is in correct position, to avoid body movement. Sit still and do not
talk or move during the measurement.
After the cuff has been appropriately positioned on the arm and connected
to the Upper Arm Type Blood Pressure Monitor, the measurement can begin:
a) Press the Stop/Start button. The pump begins to inflate the cuff. In the display, the
increasing cuff pressure is c o ntinually displayed.
b) After automatically reaching an individual pressure, the pump stop s and the pressure slowly
falls. The cuff pressure is displayed during the measurement.
c) When the device has detected your pulse, the heart symbol in the display begins to blink.
d) When the measurement has been concluded, the measured systolic and diastolic blood
pressure values, as well as the pulse will be d is played.
e) The measurement results are displayed until you switch the device off. If no button is
pressed for 60seconds, the device switches off automatically.
f)
Cuff self-checking symbol (√×)
The cuff correct symbol( √) will be displayed if the cuff position is correct, otherwise the wrong
symbol(×) will be displayed. Please check again the cuff if t h e wrong symbol(×) is displayed.
g) Movement error symbol ( )
The Movement Error Symbol (
) is displayed if you move your body during the
measurement. Please remove the cuff, and wait 2-3 minutes. Reapply the cuff and take
another measurement.
Recommended Use Methods
1. recommendation that the PATIENT relax a s much as possible and not talk during the
measurement PROCEDURE
2. recommendation that 5 min should elapse before the first reading is taken
3. any reading can be affected by the measurement site, the position of the PATIENT,
exercise, or the PATIENT’S physiologic condition
To Next Page
Loading...