To Next PageTo Next Page
Need help?Do you have a question about the Cillit Claropur BW and is the answer not in the manual?
Installation must comply with water supply company regulations and be done by certified installers.
Protect installation site from frost, chemical vapors, UV radiation, and heat sources above 40°C.
Keep plastic parts free from grease, solvents, and acidic/basic detergents. Avoid shocks.
Install flushing hose at min. 20mm distance from highest waste water level for free discharge.
Turn knob counter-clockwise to initiate backwash, then close it. Check for leaks.
Low pressure may indicate a dirty filter element; perform backwash.
If flushing outlet fails to close, ensure backwash element reaches final position; repeat backwash.
Specifies the pipe connection sizes: DN 20 (3/4") and DN 25 (1").
The flow rates are 3.0 m³/h for 3/4" and 3.5 m³/h for 1" at 0.2 bar pressure drop.
The filter element traps impurities >90 µm (lower) and >110 µm (upper).
The filter has a nominal pressure rating of 16 bar.
The recommended operating water temperature range is 5°C to 30°C.
The maximum ambient temperature for operation is 40°C.
Includes overall length, total height, and minimum installation distances.
The approximate operating weight is 1.8 kg for 3/4" and 1.7 kg for 1".
The production number (PNR) is 7-810414.
General| Brand | Cillit |
|---|---|
| Model | Claropur BW |
| Category | Water Filtration Systems |
| Language | English |
