1. Doesn't work and
Indicator light is off
4. The controller gets
hot.
Make sure the power adapter is connected well and press the
power button of the controller.
1 .There are three massage levels to choose.
2.You can adjust the width of the wrap to make the strength suitable.
3.Turn off the machine if you cannot bear the strength.
It is normal if the controller gets hot after long time use.
We suggest you can shut it down for 10 minutes.
2.Check and adjust the position and tightness, don't wrap too tight.
please read Safety Precautions carefully before use. In order to get better
massage, please wear the sleeves properly.
1.Wear the wraps on calves correctly as below.
Troubleshooting
Usage Of The Sleeves
Q5: Why does the controller get hot?
A5: As we suggest, you can use it 20 minutes per time normally. If it keeps working
too long time, the controller will get hot, it’s a normal phenomenon.
Q6: Why does the controller make a sound?
A6: The sound comes from the working air pump in the controller, providing air
continuously to the airbags in the wraps, it’s a normal phenomenon.
Product Charging Instructions
The massager will shut off automatically in 20 minutes.
2.
operation.
3. Too light or tight.
For Calves:
1. Wear the wraps on feet correctly as below.
For Feet
2. Check and adjust the position and tightness, don't wrap too tight.
Usage Of The Controller
Pause Button
Power Button
Mode Button
Air Pressure Button
Power adapter
Power adapter plug
1. Press " " button and hold for three seconds to start the machine:
• It will begin with mode 1 and strength 1 (The lowest) by default.
• It will shut off after 20 minutes (You can restart it manually).
2. Press " " button to switch and enjoy the different massage modes, the
difference between these 3 modes can be seen on Page 2.
3. Press " " button to select intensity.
1)Three pressure levels for choice. We suggest you use the lowest level at the
beginning.
2)You can change the tightness of the warps to make the strength suitable as you
like.
Power adapter plug
3 4
Cautions:
1.For first charging, please make sure the machine is fully recharged, which is good
for the battery.
2.If the light of the power button is flashing, it means that the machine is out of power.
You can continue to use it by the adapter, or stop use it until it is fully recharged.
3.When it is recharging, the indicator of power button keeps flashing; and when it is
fully recharged, the indicator is always on.
* Don't tie wraps too tightly and leave some gap as possible for the first use.
Break off during
( Take the right leg as reference. )
To Next Page
Loading...