pag. 20
User Guide
Hydraulic system
Hydraulic system allows the Dolly to perform up to six lifts. The charging
time is approximately 60 seconds. The proportional control valve allows the
arm to have a speed range from 0 to 2 seconds.
Charging of the dolly can be made in two ways:
• Electrical (depending on the preset voltage): Connect the power cable
supplied, switch on the main switch (1) and press the charging buon (2).
Charging will stop automatically once you reach the maximum pressure
of 180 Bar set by the manufacturer to avoid the damage to the Dolly. In
case of anomalous currents or voltages the electrical box is equipped with
a fuse (3) that protects the system, easily replaceable;
• The second way of charging is through a manual pump that is used only
in places where there is no electricity (as shown in image A). Insert the
control rod (g. B) into the special housing and pump it up and down
until it reaches the desired pressure.
fig.A - manual charge pump handle (configuration)
Fig. B manual pump-rod
To Next Page
Loading...