Setting Up
• The ball comes with batteries already installed. Pull the tab marked “PULL” to remove the
spacer insulating the batteries.
• To activate the lights, bounce the ball. The lights are impact-activated.
• If the spacer is broken and cannot be pulled out, or if the ball does not light up after the
spacer is removed, try following the steps in the Replacing the Batteries section below to
re-install the light unit or replace the batteries.
Replacing the Batteries
CAUTION: Do not sure a sharp tool to open the cap. It is recommended to use a key. These
procedures should be done carefully, under adult supervision ONLY.
Keep all batteries, wrenches, plastic bags and other accessories away from babies, children
and pets. They are NOT toys. They can cause injury, suffocation, poisoning or other dangers.
STEP 1
Deate the ball slightly and
use a non-sharp tool such as a
key to pry open the end cap.
Do not use a sharp tool as this
many damage the ball.
STEP 2
Use the hook of the tool to
pull out the light unit.
STEP 3
Pull the transparent tube
containing the batteries
out of the unit.
To Next Page
Loading...
