What to do if my CIRCLE FITNESS Equipment shows a COMMUNICATION FAIL error?
If your CIRCLE FITNESS Fitness Equipment displays a COMMUNICATION FAIL error, it indicates a communication timeout. First, check that the console and generator are properly connected. If the connection is correct and the error persists, the console or generator may need to be replaced.
What to do if my CIRCLE FITNESS Fitness Equipment displays a DC BUS ERROR?
If your CIRCLE FITNESS Fitness Equipment shows a DC BUS ERROR, it means the generator isn't converting AC to DC power correctly. Here’s what to do: 1. Stop pedaling and wait for the power to shut down. 2. Then, pedal again to power up the console. If the error reappears, the generator needs to be replaced.
What to do if my CIRCLE FITNESS Fitness Equipment shows a SHORT CIRCUIT error?
If your CIRCLE FITNESS Fitness Equipment displays a SHORT CIRCUIT error, it indicates that the IGBT of the generator is short-circuited. To resolve this: 1. Stop pedaling and wait for the power to shut down. 2. Pedal to power up the console again. If the error message continues to appear, the generator should be replaced.
What to do if my CIRCLE FITNESS Fitness Equipment displays a CMP CURR OVERCURR error?
If your CIRCLE FITNESS Fitness Equipment shows a CMP CURR OVERCURR error, it means the generator's output current has exceeded 3.5 amps for 1 second. Here’s how to address it: 1. Stop pedaling and wait for the power to shut down. 2. Pedal to power up the console. If the error message appears again, consider replacing the generator.
What to do if my CIRCLE FITNESS Fitness Equipment displays a DCV VOLT OVERLOAD error?
If your CIRCLE FITNESS Fitness Equipment displays a DCV VOLT OVERLOAD error, it means the DC generator voltage is too high (over 300V for 3 seconds), usually caused by pedaling too fast (over 180 RPM). To fix this: 1. Stop pedaling and allow the power to shut down. 2. Pedal to power up the console. If the error persists, the generator may need replacement.
What to do if my CIRCLE FITNESS Fitness Equipment displays a CURRENT STATE NG error?
If your CIRCLE FITNESS Fitness Equipment displays a CURRENT STATE NG error, it suggests an issue with the generator's output circuit or a disconnection between the coil and controller. First, check the coil connection. If the connection is correct and the error continues, consider replacing the generator.
Why does my CIRCLE FITNESS Fitness Equipment show a LOW BATTERY error?
Your CIRCLE FITNESS Fitness Equipment shows a LOW BATTERY error because the battery voltage is too low. If the error message continues to appear after some time, replace the battery.
General| Resistance Levels | 16 |
|---|---|
| Display | LCD |
| Stride Length | 18 inches |
| Dimensions | 70" L x 25" W x 68" H |
| Programs | 12 |
| Console Display | LCD |
| Display Type | LCD |
| Type | Elliptical |
To Next Page
