Ciro TWIN RAIL - Page 2

G0160505 REV. -
PAGE 2
5. Install the Twin Rail Footrests and adjust the angle to your liking.
NOTE: Adjust the angle of the extension arm to affect the height of the footrest. (A.)
Adjust the angle of the clevis aached to the extension arm to affect how the footrest folds. (B.)
Adjust the angle of the footrest on the footrest adapter to find a comfortable posion. (D.)
6. Check and securely ghten all fasteners.
CAUTION: Ciro recommends a thread locking fluid such as 3M Scotch-Weld TL-43 for this installaon.
(A.) 1/2” hex bolt holding the clamp and extension arm should be ghtened to 40-45 .-lb. torque.
(B.) 3/8” socket head screw aaching the clevis to the extension arm should be ghtened to 12-16 .-lb. torque.
(C.) 3/8” socket head screw in the clevis should be ghtened to 12-16 .-lb. torque.
(D.) 5/16” socket head screw in the footrest should be ghtened to 10-13 .-lb. torque.
FIG.2
CLICK TAB SPRING
MALE CLAMP HALF
FEMALE CLAMP HALF
Serrated face
CLEVIS
FOOTREST ADAPTER
TWIN RAIL FOOTREST
HEX BOLT
1/2”-13 x 1 3/8”
FLAT WASHER
1/2”
SOCKET HEAD SCREW
3/8”-16 x 1 3/8”
BUTTON HEAD SCREW
4-40 x .375
“D” SPRING
NARROW WASHER
5/16”
SOCKET HEAD SCREW
5/16”-18 x 1”
(A.)
(B.)
(D.)
SOCKET HEAD SCREW
3/8”-16 x 1”
(C.)
EXTENSION ARM
HIGH COLLAR LOCK WASHER
5/16”