4
2: eHandle
2.1 Specifications and F
Specifications
Power supply requirement:
Handles
shall receive power via RJ45 connector through custom patch cable conn
distribution unit
‐ eHandle
shall be powered by 5VDC power source
‐ 5VDC tolerance: ±10%
‐ Standby current: 50mA Max
‐
Typical operating current shall be less than 500mA @ 5VDC
‐
Maximum peak/stall operating current shall be less than 1,150mA @ 5VDC
Four types of Handle
Electronic Rack
shall receive power via RJ45 connector through custom patch cable conn
ected to CIS manufactured power
shall be powered by 5VDC power source
Typical operating current shall be less than 500mA @ 5VDC
Maximum peak/stall operating current shall be less than 1,150mA @ 5VDC
User Manual
ected to CIS manufactured power
To Next Page
Loading...