Cisco 1120 - Page 10

52
Figure 7 Router Power and Reset Buttons
Item Button Description
1 CONFIG Reset Press the CONFIG Reset button for at least 5 seconds to return the router software
configuration to the factory default, and power cycle the router. Power cycling the router
turns the router off, then immediately back on. The router will temporarily stop operating on
the network during the power cycle, then resume operating when the power cycle process
is complete.
2 PWR RESET Press the PWR RESET button for at least 5 seconds to power cycle the router. Power cycling
the router turns the router off, then immediately back on. The router will temporarily stop
operating on the network during the power cycle, then resume operating when power cycle
process is complete.
302332
RESET
SPD
EN
SFP 0/1
SPD
EN
SFP 0/0
GE 0/1 GE 0/0
FE 0/5 FE 0/4
FE 0/3 FE 0/2
FE 0/1 FE 0/0
ALARM
OUT 1
IN 4 IN 3 IN 2 IN 1
GPS
WIFI
ACT
SYS
ALARM
CONSOLE
POWER
PE N L3 L2 L1
+
-
1 2