Cisco 1600 series - Page 14

Installation instruction
Siemens Remote Service COIT-000.812.04.02.02 Seite 14/14 Siemens AG
Rev. 02 02-02 CO SGK Medical Solutions
GHVFULSWLRQ 5RXWHUSURPSW FRPPDQG
6WHS
Enter into the enable modus of
the router
jac0356323qc828>
HQDEOH
6WHS
Enter the password to get into
the enable modus (this entry is
not visible)
password:
SUHVHF
6WHS
Enter into the configuration
modus of the router
jac0356323qc828#
FRQILJXUHWHUPLQDO
The following output will appear
Enter configuration
commands, one per line.
End with CNTL/Z.
6WHS
set the ip for modem1
jac0356323qc828(config)#
LSKRVWPRGHP

6WHS
Enter ctrl-z
jac0356323qc828(config)#
A]
The following output will appear
3d22h: %SYS-5-CONFIG_I:
Configured from console
by console
6WHS
log onto the modem
jac0356323qc828#
PRGHP
The following output will appear
Trying modem1
(10.6.254.2, 2001)...
Open
User Access Verification
6WHS
Enter the username
username
SUHUGLDJ
6WHS
Enter the password (not visible)
password
SUHVHW
The following output will appear
Password OK
6WHS
Echo on
DWH
The following output will appear
OK
6WHS
Reset to factory settings.
1RWH: 0 is „zero“
DWIZ
The following output will appear
OK
6WHS
Press ctrl-shift-6
A>VKLIW@
6WHS [
6WHS
Disconnect from the modem
jac0356323qc828#
GLVFRQQHFW
6WHS
Confirm that the connection to
modem1 shall be closed
Closing connection to
modem1 [confirm]
FU!
6WHS H[LW
Now your modem and your router are ready to be remotely configured by SIEMENS Remote Services.
$SSHQGL[.,6'1XVHRIWKHDQDORJURXWHU
1RWH Should it become necessary to switch from the analog connection to an ISDN connection, the
configuration can be done via the analog port of the router.