Optional Installations 3-3
Installing the WAN Interface Card in the Router
Installing the WAN Interface Card in the Router
Follow these steps to install the card in a Cisco 1600 series router:
Step 1 Turn the router OFF, and disconnect the cable from the socket labeled 14 VDC
on the rear panel of the router.
Step 2 Loosen the captive screws on the WAN interface card-slot cover on the rear
panel of the router (Figure 3-1).
Figure 3-1 Removing the Slot Cover (Cisco 1601 Shown)
Step 3
Remove the metal plate that covers the WAN interface card slot.
Step 4 Hold the WAN interface card by the front panel, and line up the edges of the card
with the guides (Figure 3-2).
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
H7179
WAN interface card slot cover
To Next Page
Loading...
