© 2005 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 9 of 16
tunnel source FastEthernet0/0
tunnel destination 10.0.149.221
tunnel key 100000
tunnel protection ipsec profile SDM_Profile1
!
interface Tunnel1
bandwidth 1000
ip address 192.168.2.10 255.255.255.0
ip mtu 1400
ip nhrp authentication DMPVN_BU
ip nhrp map 192.168.2.1 10.0.149.220
ip nhrp network-id 100001
ip nhrp holdtime 360
ip nhrp nhs 192.168.2.1
ip nhrp server-only
ip tcp adjust-mss 1360
delay 1000
cdp enable
tunnel source FastEthernet0/0
tunnel destination 10.0.149.220
tunnel key 100001
tunnel protection ipsec profile SDM_Profile2
!
interface Ethernet0/0
ip address 192.168.16.1 255.255.255.0
half-duplex
!
interface FastEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$
ip address dhcp
speed 100
full-duplex
!
ip classless
ip route 10.0.149.0 255.255.255.0 dhcp
!
end
Verifying the Cisco 1751 Spoke Router Results
This section provides information that can be used to confirm that the configuration is working properly.
c1751-16#show ip route
Codes: C-connected, S-static, R-RIP, M-mobile, B-BGP
D-EIGRP, EX-EIGRP external, O-OSPF, IA-OSPF inter area
To Next Page
Loading...
Need help?
General
