EasyManuals Logo

Cisco 1941W User Manual

Cisco 1941W
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
42
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
CFM Support on Routed Port and Port MEP
Total Remote MEPs: 4
Use the show ethernet cfm maintenance-points remote command to view the details of a remote
maintenance point domain:
On router 1:
Router1#show ethernet cfm maintenance-points remote domain carrier service carrier
--------------------------------------------------------------------------------
MPID Domain Name MacAddress IfSt PtSt
Lvl Domain ID Ingress
RDI MA Name Type Id SrvcInst
EVC Name Age
Local MEP Info
--------------------------------------------------------------------------------
43 carrier 5657.a86c.fa92 Up Up
2 carrier Gi0/2
- carrier S,C 100,1101 N/A
N/A 0s
MPID: 44 Domain: carrier MA: carrier
Total Remote MEPs: 1
On router 2:
Router2#show ethernet cfm maintenance-points remote domain carrier service carrier
--------------------------------------------------------------------------------
MPID Domain Name MacAddress IfSt PtSt
Lvl Domain ID Ingress
RDI MA Name Type Id SrvcInst
EVC Name Age
Local MEP Info
--------------------------------------------------------------------------------
44 carrier 5657.g945.04fa Up Up
2 carrier Gi0/2
- carrier S,C 100,1101 N/A
N/A 0s
MPID: 43 Domain: carrier MA: carrier
Use the ping command to verify if Loopback Messages (LBM) and Loopback Replies (LBR) are
successfully sent and received between the routers:
Router1#ping ethernet mpid 44 domain carrier service carrier cos 5
Type escape sequence to abort.
Sending 5 Ethernet CFM loopback messages to 5657.a86c.fa92, timeout is 5 seconds:!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
Router1#
Use the traceroute command to send the Ethernet CFM traceroute messages:
Router#traceroute ethernet mpid 44 domain carrier service carrier
Type escape sequence to abort. TTL 64. Linktrace Timeout is 5 seconds
Tracing the route to 5657.a86c.fa92 on Domain carrier, Level 2, service carrier
Traceroute sent via Gi0/2
B = Intermediary Bridge
! = Target Destination
* = Per hop Timeout
--------------------------------------------------------------------------------
MAC Ingress Ingr Action Relay Action
Hops Host Forwarded Egress Egr Action Previous Hop
--------------------------------------------------------------------------------

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 1941W and is the answer not in the manual?

Cisco 1941W Specifications

General IconGeneral
BrandCisco
Model1941W
CategoryNetwork Router
LanguageEnglish

Related product manuals