Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers 3
Memory Options
Memory Options
Table 1 describes default memory and upgrade options for Cisco 2600 series.
Routers and Interfaces Supported
The Cisco 2600 series includes the following routers:
• Cisco 2610
• Cisco 2611
• Cisco 2612
• Cisco 2613
• Cisco 2620
• Cisco 2621
These routers support the interfaces shown in Table 2.
Note Part numbers without an equals sign (=) identify products installed in a router at the factory.
Part numbers followed by an equals sign identify the same products sold as spares (separately).
Table 1 Cisco 2600 Series Default Memory and Upgrade Options
Memory Type Default Upgrade Options
Flash 8 MB 16 MB Flash SIMM: MEM2600-16FS=
16 MB Flash SIMM: MEM2600-8U16FS=
DRAM 24 MB
1
1 Routers shipped after February 16, 2000, have 32 MB DRAM.
24 to 32 MB DRAM: MEM2600-24U32D=
24 to 48 MB DRAM: MEM2600-24U48D=
24 to 64 MB DRAM: MEM2600-24U64D=
DRAM DIMM 24 MB 4 MB DRAM DIMM: MEM2600-4D=
8 MB DRAM DIMM: MEM2600-8D=
16 MB DRAM DIMM: MEM2600-16D=
32 MB DRAM DIMM: MEM2600-32D=
Table 2 Interfaces Supported on Cisco 2600 Series Routers
Interface, Network Module, or Data Rate
1
Routers Supported
LAN Interfaces
2
1- or 2-port Ethernet (10BaseT) Cisco 2610, Cisco 2611, Cisco 2612
1-port Token Ring (RJ-45) Cisco 2612, Cisco 2613
1- or 2-port Ethernet (10/100BaseT) Cisco 2620, Cisco 2621
LAN Network Modules
1-port Ethernet All Cisco 2600 series routers
4-port Ethernet All Cisco 2600 series routers
1-port ATM-25 RJ-45 interface All Cisco 2600 series routers
Serial Network Modules
16- or 32-port asynchronous All Cisco 2600 series routers
4- or 8-port asynchronous/synchronous serial low speed
(128 kbps max)
All Cisco 2600 series routers
To Next Page
Loading...
