EasyManuals Logo

Cisco 3800 Series User Guide

Cisco 3800 Series
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Router(config)#^Z
00:01:54: %SYS−5−CONFIG_I: Configured from console by console
Router#show ip interface brief
Interface IP−Address OK? Method Status Protocol
Ethernet0/0 10.200.40.37 YES TFTP administratively down down
Serial0/0 unassigned YES TFTP administratively down down
BRI0/0 193.251.121.157 YES unset administratively down down
BRI0/0:1 unassigned YES unset administratively down down
BRI0/0:2 unassigned YES unset administratively down down
Ethernet0/1 unassigned YES TFTP administratively down down
Serial0/1 unassigned YES TFTP administratively down down
Loopback0 193.251.121.157 YES TFTP up up
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface Ethernet0/0
Router(config−if)#no shutdown
Router(config−if)#
00:02:14: %LINK−3−UPDOWN: Interface Ethernet0/0, changed state to up
00:02:15: %LINEPROTO−5−UPDOWN: Line protocol on Interface Ethernet0/0,
changed state to up
Router(config−if)#interface BRI0/0
Router(config−if)#no shutdown
Router(config−if)#
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0:1, changed state to down
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0:2, changed state to down
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0, changed state to up
00:02:115964116991: %ISDN−6−LAYER2UP: Layer 2 for Interface BR0/0,
TEI 68 changed to up
Router(config−if)#^Z
Router#
00:02:35: %SYS−5−CONFIG_I: Configured from console by console
Router#copy running−config startup−config
Destination filename [startup−config]?
Building configuration...
[OK]
Router#show version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600−IS−M), Version 12.0(7)T, RELEASE SOFTWARE (fc2)
Copyright (c) 1986−1999 by cisco Systems, Inc.
Compiled Tue 07−Dec−99 02:21 by phanguye
Image text−base: 0x80008088, data−base: 0x80C524F8
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Router uptime is 3 minutes
System returned to ROM by abort at PC 0x802D0B60
System image file is "flash:c2600−is−mz.120−7.T"
cisco 2611 (MPC860) processor (revision 0x202)
with 26624K/6144K bytes of memory.
Processor board ID JAB031202NK (3878188963)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non−volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read/Write)
8192K bytes of processor board System flash partition 2 (Read/Write)
Configuration register is 0x2142
Router#configure terminal

Other manuals for Cisco 3800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3800 Series and is the answer not in the manual?

Cisco 3800 Series Specifications

General IconGeneral
Connectivity TechnologyWired
ModelsCisco 3825, Cisco 3845
Operating SystemCisco IOS
Routing ProtocolsBGP, OSPF, EIGRP, RIP, IS-IS
InterfacesFast Ethernet, Gigabit Ethernet, Serial, ISDN BRI, Voice
WAN InterfacesT1/E1, ISDN BRI, Serial
Security FeaturesFirewall, VPN, IPS, SSH
Voice SupportYes
Network ManagementSNMP, CLI
Product TypeRouter
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network/Transport ProtocolTCP/IP
FeaturesQuality of Service (QoS)
RAM256 MB
Flash Memory64 MB
Product SeriesCisco 3800 Series

Related product manuals