EasyManuals Logo

Cisco 4000 Series Upgrade Manual

Cisco 4000 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory 7
Accessing the Internal Components of the Router
Step 7 Support the component tray with one hand, push down on the safety latch tab, and pull the
component tray out the rest of the way.
Step 8 Set the component tray on your work surface.
Proceed to the next section, “Removing Network Processor Modules.”
Removing the Component Tray from a Chassis without a Safety Latch
Take the following steps to remove the component tray from a chassis without a safety latch:
Step 1 Turn OFF the system power.
Step 2 Attach your ESD-preventive wrist strap.
Step 3 Remove all network and power cables.
Step 4 If you have a DC-powered router, take these steps to remove the power cables:
Warning Before performing any of the following procedures, ensure that power is removed from
the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that
services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of
the circuit breaker in the OFF position.
Use a screwdriver to loosen the captive installation screws on the terminal block cover.
Lift and remove the terminal block cover.
Use a screwdriver to remove the three power leads from the terminal block in the
following order: negative, positive, then ground.
Step 5 Loosen the nonremovable chassis release screw on the rear panel of the chassis. (See
Figure 4.)
Figure 4 Component Tray Removal for Chassis without a Safety Latch
AUX
CONSOLE
INPUT 100-240VAC 50/60HZ 3.0-1.5 AMPS
H2899
Rear of the chassis
Handle
Support the component
tray with your hand
Chassis shell
Chassis release 
screw

Other manuals for Cisco 4000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4000 Series and is the answer not in the manual?

Cisco 4000 Series Specifications

General IconGeneral
CategoryNetwork Router
Product TypeRouter
Form FactorRack-mountable
Connectivity TechnologyWired
Product FamilyCisco 4000 Series
Operating SystemCisco IOS XE
DimensionsVaries by model
WeightVaries by model
ModelCisco 4000 Series
WAN PortsVaries by model
LAN PortsVaries by model
StorageVaries by model
RedundancyVaries by model
Security FeaturesVaries by model
Network ManagementVaries by model
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network/Transport ProtocolTCP/IP, UDP
FeaturesVaries by model
InterfacesVaries by model
ModelsVaries
Network InterfacesVaries by model
Power SupplyVaries by model
Virtualization SupportYes

Related product manuals