4-18
Cisco 6160 Hardware Installation Guide
OL-2190-02 B0
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Installation Procedures
Figure 4-10 shows the cabling for a DS3 subtended network configuration.
Figure 4-10 Cabling for DS3 Subtended Network Configuration
Step 3 On the first subtended node chassis backplane, attach the end of the coaxial cable used in Step 2 to the
RX BNC for DS3 Port 1 on the I/O card.
Step 4 On the subtending host chassis backplane, attach one end of a coaxial cable to the RX BNC connector
for DS3 Port 2 on the I/O card.
Step 5 On the first subtended node chassis backplane, attach the end of the coaxial cable used in Step 4 to the
TX BNC connector for DS3 Port 1 on the I/O card.
Step 6 On the subtending host chassis backplane, attach one end of a coaxial cable to the TX BNC connector
for DS3 Port 3 on the I/O card.
Step 7 On the first subtended node chassis backplane, attach the end of the coaxial cable used in Step 6 to the
RX BNC for DS3 Port 1 on the I/O card.
Step 8 On the subtending host chassis backplane, attach one end of a coaxial cable to the RX BNC connector
for DS3 Port 3 on the I/O card.
TX
RX
TX
RX
TX
RX
PORT 1
PORT 2
PORT 3
60V,1A MAX
P1
P5
P4
P3
P2
TX
RX
TX
RX
TX
RX
PORT 1
PORT 2
PORT 3
60V,1A MAX
P1
P5
P4
P3
P2
TX
RX
TX
RX
TX
RX
PORT 1
PORT 2
PORT 3
60V,1A MAX
P1
P5
P4
P3
P2
Receive
Transmit
Receive
Transmit
Receive
Transmit
Receive
Transmit
54016
Network
1st subtended
node chassis
Subtending
host chassis
2nd subtended
node chassis
To Next Page
Loading...