4-29
Cisco 6160 Hardware Installation Guide
OL-2190-02 B0
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Installation Procedures
First, would you like to see the current interface summary? [yes]: yes
Interface IP-Address OK? Method Status Protocol
ATM0/0 70.0.0.2 YES NVRAM up up
Ethernet0/0 172.27.32.156 YES NVRAM up up
ATM0/1 unassigned YES unset down down
ATM0/2 unassigned YES unset administratively down down
ATM18/0 unassigned YES unset initializing down
ATM18/1 unassigned YES unset initializing down
ATM18/2 unassigned YES unset initializing down
ATM18/3 unassigned YES unset initializing down
ATM21/0 unassigned YES unset administratively down down
ATM21/1 unassigned YES unset administratively down down
ATM21/2 unassigned YES unset administratively down down
ATM21/3 unassigned YES unset administratively down down
ATM26/0 unassigned YES unset down down
ATM26/1 unassigned YES unset down down
ATM26/2 unassigned YES unset down down
ATM26/3 unassigned YES unset down down
Configuring global parameters:
Enter host name [DSLAM]: sw-ni2-2
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: lqb
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password [lab]: lab
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password [lab]:
Configure SNMP Network Management? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]: no
Configuring interface parameters:
Do you want to configure ATM0/0 interface? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [70.0.0.2]:
Subnet mask for this interface [255.0.0.0] :
Class A network is 70.0.0.0, 8 subnet bits; mask is /8
Do you want to configure Ethernet0/0 interface? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [172.27.32.156]:
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.27.0.0, 16 subnet bits; mask is /16
Do you want to configure ATM0/1 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM0/2 interface? [no]:
Do you want to configure ATM18/0 interface? [yes]:
Configure IP on this interface? [no]:
To Next Page
Loading...