Cisco 6160 - Page 30

4-30
Cisco 6160 Hardware Installation Guide
OL-2190-02 B0
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Installation Procedures
Do you want to configure ATM18/1 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM18/2 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM18/3 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM21/0 interface? [no]:
Do you want to configure ATM21/1 interface? [no]:
Do you want to configure ATM21/2 interface? [no]:
Do you want to configure ATM21/3 interface? [no]:
Do you want to configure ATM26/0 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM26/1 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM26/2 interface? [yes]:
Configure IP on this interface? [no]:
Do you want to configure ATM26/3 interface? [yes]:
Configure IP on this interface? [no]:
The following configuration command script was created:
hostname sw-ni2-2
enable secret 5 $1$12Lo$vGKa1wlRcNyw06j1bgGQd0
enable password lab
line vty 0 4
password lab
no snmp-server
!
ip routing
!
interface ATM0/0
ip address 70.0.0.2 255.0.0.0
!
interface Ethernet0/0
ip address 172.27.32.156 255.255.0.0
!
interface ATM0/1
no ip address
!
interface ATM0/2
shutdown
no ip address
!
interface ATM18/0
no ip address
!
interface ATM18/1
no ip address
!
interface ATM18/2
no ip address
!
interface ATM18/3
no ip address