Cisco Systems, Inc.
All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Page 10 of 12
• Telnet—A terminal emulation protocol that allows remote access to the administrative interface of a switch over
the network (in-band)
• UDP—Enables an application (such as an SNMP agent) on one system to send a datagram to an application (a
network management station using SNMP) on another system; uses IP to deliver datagrams; TFTP uses UDP/IP
protocol suites
• Dynamic Host Connection Protocol (DHCP)—Lets a host automatically obtain their IP address, subnet mask,
and default route from a pre-configured DHCP server on the network
• Hot Standby Router Protocol (HSRP)—Provides fast cut-over to a backup router in the event of a system or link
failure
Product Regulatory Approvals and Compliance
Product Regulatory Compliance
The following table lists regulatory compliance standards for the Cisco 7204VXR and 7206VXR chassis.
Product System Requirements
Hardware Requirements
Hardware for Cisco 7200 Series Router includes:
• 7204VXR or Cisco 7206VXR chassis
• Network Processing Engine or Network Services Engine
• Input/Output controller
• Processor memory
• Input/Output controller memory
• Power supply
• Console and auxiliary cables
• Second power supply, accessories
• Port adapters
• Service adapters
Note:
You must order an input/output controller and a network processing engine for the Cisco 7206VXR and
Cisco 7204VXR.
Table 8
Compliance Standard
Product Safety UL 1950, CSA 22.2 No. 950, EN60950, EN41003, AUSTEL TS001, AS/NZ 3260, IEC 950
Emissions FCC Class A, CSA Class A, EN55022 Class B, VCCI Class 2, AS/NRZ 3548 Class A
Immunity IEC-1000-4-2, IEC-1000-4-3, IEC-1000-4-4, IEC-1000-4-5, IEC-1000-4-6, IEC-1000-4-11, IEC-1000-3-2
NEBS Level 3
To Next Page
Loading...
